HYDRONEUMATIC DEPOSITS
Hydropneumatic tanks are containersclosed where water accumulates under pressure.This water storage weallows to have an amountDetermine and avoid pressure spikes.Once the water consumption has started, the pump does notit will start working until the moment whenthe pressure drops to a minimum, avoiding thismode the constant starts and stops in additionwater hammer
Precharge kit VGU
The universal inflation checker type OLAER VGU, is the indispensable instrument to verify the inflation and the nitrogen purge of allaccumulators on the market, up to the maximum operating pressure of 340 bar-600 bar, according to flexible.This is connected directly to the inflation valve of the accumulator by means of a flexible to the nitrogen bottle. To check the pressure orwell to discharge the accumulator, the flexible is not necessary
Safety Block Type SB 24
The blocks SB 24 are designed to regroup in a single compact component all the necessaryorgans for a good operation of a Hydraulic installation with hydroneumatic accumulator.The components of the blocks DI 16 basically are:- 1 ball valve with closing by handle turn of 90º in order to isolate the accumulator of thegeneralcircuit.- 1 pressure relief valve regulated at maximum pressure of the accumulator (never this valve mustbe used as a protection of the hydraulic pump)
Safety Block type SB 16
The blocks SB 16 are designed to regroup in a single compact component all the necessaryorgans for a good operation of a Hydraulic installation with hydroneumatic accumulator.The components of the blocks SB 16 basically are:- 1 ball valve with closing by handle turn of 90º in order to isolate the accumulator of the generalcircuit.- 1 pressure relief valve regulated at maximum pressure of the accumulator (never this valve mustbe used as a protection of the hydraulic pump)
Vertical Anti-Water Hammer Used Water Serie EUV
Currently some pipes resist vacuum and high pressures. But the speed of propagation of thepressure wave is very high and the pipes go from depression to overpressure in a few seconds and sometimesin fractions of a second.A Hydraer bladder antiariete must be installed because times are extended, allowing the materialadapt to pressure variations and also because it controls not only overpressures (pipeshave a maximum pressure limit) but also depressions, the joints are not designed towithstand depressions and internal coatings break down losing their properties.